Will the stock X.01 11spd cage readily accept a cog size larger than 42T?
Looking to swap a worn X.01 drivetrain out with a much lesser worn one including a SunRace 11-46 cassette.
Bro, Brah, Bruh
Will the stock X.01 11spd cage readily accept a cog size larger than 42T?
Looking to swap a worn X.01 drivetrain out with a much lesser worn one including a SunRace 11-46 cassette.
Bro, Brah, Bruh
I've seen it done on a hardtail. But on a fully you might have too much chain growth to deal with it. But you can probably swap an eagle cage on there, there's a lot of cross pollination btw 11 and 12.
I have the sun race 11-46 with the xo1 11 spd, works great
Nice. The drivetrain is getting swapped from a FS to a hardtail so it sounds like it should be good to go. Was trying to figure out if I needed an extended cage and to go with the pulley wheels I need.
I had a xx1 11 speed rear mech that got twisted by a tree branch that snagged the cage. I replaced it with a garbaruk cage of aliexpress. I am pretty sure it's just a knock off but it works perfectly. The pully wheels are much larger and if you ran into difficulty and wanted to run bigger cogs, it would probably do the trick for a very low cost.
Posted by: jgshinton
I've seen it done on a hardtail. But on a fully you might have too much chain growth to deal with it. But you can probably swap an eagle cage on there, there's a lot of cross pollination btw 11 and 12.
I have done the same on my hardtail. Cant say it it would work on a fully.
Posted by: RAHrider
I had a xx1 11 speed rear mech that got twisted by a tree branch that snagged the cage. I replaced it with a garbaruk cage of aliexpress. I am pretty sure it's just a knock off but it works perfectly. The pully wheels are much larger and if you ran into difficulty and wanted to run bigger cogs, it would probably do the trick for a very low cost.
That was the plan if it didn't fit. Garbaruk cage and pulleys. Pulleys ordered for sure regardless
Forum jump: