i just bought some new arrow racing tires (launch model) and it wont seal onto the rim? any suggestionsa on how to get iut to stay on?
why..
glue!!!!!!!!! hmm ive never had any probs….. bike shop!?
Over-inflate it tonight. It should seat itself at some point, and seal up good. Just remember to release some air before you ride it though.
so i would half to do this every time because i wouldnt wanna wait a few hours if i flatted for it to seal in
ride around on it the tire is prob just new and u can wear it in??? dont do any thing hard core like case a curb tho lol :) run low psi for that aswell should seat :)
just use duck tape…….it s mans best friend…
what kinda rim are you using? me and my friend both ride launches, but i use rhynolite XLs and he uses doubletracks (hack :) ) hmmmm… not sure whats up.
I. M. :canada:
"I wrestle warthogs for nickels"
I had the same problem with my Arrow, you just have to pull hard on the side of the tire until the bead catches properly. They have 2 levels on the sidewall for different width rims (I think), do this with low air pressure, it is easoer to flex the tire.
Originally posted by Tonestar
I had the same problem with my Arrow, you just have to pull hard on the side of the tire until the bead catches properly. They have 2 levels on the sidewall for different width rims (I think), do this with low air pressure, it is easoer to flex the tire.
i did but when one side cathces other side goes out…….. i rode around with it on low pressure to and still dont work
Forum jump: