A few questions about replacing my bearings in my front and rear hubs.
The front one is a no name brand. The bearings are pretty close to done. I have re greased them a few times over the years just by removing the dust covers and using my fingers to force grease into the ball bearings. I see no way to get these bearing out of the hub to replace them. I have tried to move the sleeve in the middle of the hub to the side so I could pound out the bearing but I cant get it to move enough to get a purchase on the bearing with a punch.
Any ideas how to get these bearings out?
The rear hub is an atomic laboratories hub. Is there any way to get grease into this hub?