New posts

Marzocchi direct mount stem

April 10, 2005, 7:19 p.m.
Posts: 0
Joined: Dec. 4, 2004

You all have been very helpful! Thanks again.

"The Attention Deficit Disorder Association's Book of Wild Animals of
Western Eur- Hey! Let's Go Ride Our Bikes!"

Check out my pipes at www.thomasjlipspipeworks.wordpress.com

April 10, 2005, 7:44 p.m.
Posts: 2935
Joined: May 8, 2003

I have one from a 2004 super t, it's just four bolts from under the top crown, no steer tube clamp. If it will work it's yours for cheap.

So many freaks, so few circuses.

April 10, 2005, 9:19 p.m.
Posts: 121
Joined: Sept. 1, 2004

i have one too….willing to trade to anyone for a short oversize stem

April 11, 2005, 1:06 a.m.
Posts: 1426
Joined: Feb. 18, 2005

i run integrated on my 03 Super T's for a year

and ended up going through 3 stems :(

using the integrated with RF Diablous 31.8mm bars, when i took a hard digger into the ground, the bar could not bend due to burlyness, the stem was the weak point and ended up twisted

it did feel amazing when cornering and honking on bars, no movement, just the forks going up and down…

the integrated stems were not cheap to replace…but riding with off-angle bars is not my thing

when i got my 888's, i agonised about integrated, but didn't bother and got Easton Vice 50mm and EAD-50 31.8mm bars, no problems since, just get out allen key and straighten stem!

my new setup doesn't actually feel much different compared to the integrated?

Mythic / Da Kine / Esher Shore / Freeborn

http://hampsteadbandit.blogspot.com/

Forum jump: