I'm having a mental block on this - call it analysis paralysis. Show me (or please provide a simple parts list) of a DIY bearing kit for pivot bearings.
Option #1 - two sockets on either end of the part and press together with a C-clamp and close one into the cavity of the other. Press back in using the old bearing to match
Option #2 - threaded rod (or carriage bolt) with a handful of washers....here's where I struggle. I'm doing 6801 bearings, so 21mm diameter (5mm inner). Do I use a 1/4 or 5/16 bolt with a 3/4" or 5/8" washer set? or does it matter? Do I get bigger ones to go on top of sockets? I'm feeling like I could sort this out at Rona for <$10...but I keep spinning on what to get.
Option #3 - stop being stupid and just buy the kit: https://www.bocabearings.com/products/bike-but-001-bearing-installer-18438